Dell Force10 S4820T FTOS Command Reference Guide - Page 308

www.dell.com | support.dell.com Defaults Not configured. Command Modes ROUTER BGP ADDRESS FAMILY ROUTER BGP ADDRESS FAMILY IPv6 Usage Information At least one of the routes included in the aggregate address must be in the BGP routing table for the configured aggregate to become active. Do not add the as-set parameter to the aggregate, if routes within the aggregate are constantly changing as the aggregate will flap to keep track of the changes in the AS_PATH. In route maps used in the suppress-map parameter, routes meeting the deny clause are not suppress; in other words, they are allowed. The opposite is true: routes meeting the permit clause are suppressed. If the route is injected via the network command, that route will still appear in the routing table if the summary-only parameter is configured in the aggregate-address command. The summary-only parameter suppresses all advertisements. If you want to suppress advertisements to only specific neighbors, use the neighbor distribute-list command. In the show ip bgp command, aggregates contain an 'a' in the first column and routes suppressed by the aggregate contain an 's' in the first column. Command History . Version 8.3.19.0 Version 8.3.7.0 Version 7.8.1.0 Version 7.7.1.0 Introduced on the S4820T. Introduced on the S4810. Introduced support on S-Series Introduced support on C-Series bgp add-path Allow the advertisement of multiple paths for the same address prefix without the new paths replacing any previous ones. Syntax Parameters bgp add-path [send | receive | both] count send receive Enter this keyword to indicate that the system will send multiple paths to peers. Enter this keyword to indicate that the system will accept multiple paths from peers. 308 | Border Gateway Protocol IPv4 (BGPv4)