Dell Force10 S4820T FTOS Command Reference Guide - Page 774

www.dell.com | support.dell.com Parameters ipv6-address prefix-length Enter the IPv6 address in the x:x:x:x::x format followed by the prefix length in the /x format. Range: /0 to /128 Note: The :: notation specifies successive hexadecimal fields of zeros Defaults Command Modes No default values or behavior INTERFACE Command History Version 8.3.19.0 Version 8.3.7.0 Version 8.4.1.0 Version 8.2.1.0 Version 7.8.1.0 Version 7.4.1.0 Introduced on the S4820T Introduced on the S4810 Support added on the management Ethernet port. Introduced on E-Series ExaScale Introduced on C-Series and S-Series Introduced on E-Series TeraScale Example Usage Information FTOS(conf)#interface gigabitethernet 10/0 FTOS(conf-if-gi-10/0)#ipv6 address ? X:X:X:X::X IPv6 address FTOS(conf-if-gi-10/0)#ipv6 address 2002:1:2::3 ? Prefix length in bits FTOS(conf-if-gi-10/0)#ipv6 address 2002:1:2::3 /96 ? FTOS(conf-if-gi-10/0)#ipv6 address 2002:1:2::3 /96 FTOS(conf-if-gi-10/0)#show config ! interface GigabitEthernet 10/0 no ip address ipv6 address 2002:1:2::3 /96 no shutdown FTOS(conf-if-gi-10/0)# FTOS allows multiple IPv6 addresses to be configured on an interface. When the no ipv6 address command is issued without specifying a particular IPv6 address, all IPv6 addresses on that interface are deleted. ipv6 control-plane icmp error-rate-limit Configure the maximum number of ICMP error packets per second that can be sent per second. Syntax ipv6 control-plane icmp error-rate-limit {1-200} Parameters To restore the default value, use the no ipv6 control-plane icmp error-rate-limit command. pps Enter the maximum number of error packets to be generated per second. Range: 1 to 200, where 0 disables the rate-limiting. Command Modes CONFIGURATION 774 | IPv6 Basics