Dell Force10 S4820T FTOS Command Reference Guide - Page 361

Parameters Defaults Command Modes Usage Information Related Commands Command History ip-address mask route-map map-name Enter an IP address in dotted decimal format of the network. Enter the mask of the IP address in the slash prefix length format (for example, / 24). The mask appears in command outputs in dotted decimal format (A.B.C.D). (OPTIONAL) Enter the keyword route-map followed by the name of an established route map. Only the following ROUTE-MAP mode commands are supported: • match ip address • set community • set local-preference • set metric • set next-hop • set origin • set weight If the route map is not configured, the default is deny (to drop all routes). Not configured. ROUTER BGP FTOS software resolves the network address configured by the network command with the routes in the main routing table to ensure that the networks are reachable via non-BGP routes and non-default routes. redistribute Redistribute routes into BGP. Version 8.3.19.0 Version 8.3.7.0 Version 7.8.1.0 Version 7.7.1.0 Introduced on the S4820T. Introduced on the S4810. Introduced support on S-Series Introduced support on C-Series network backdoor c e s Specify this IGP route as the preferred route. Syntax Parameters network ip-address mask backdoor To remove a network, use the no network ip-address mask backdoor command. ip-address mask Enter an IP address in dotted decimal format of the network. Enter the mask of the IP address in the slash prefix length format (for example, / 24). The mask appears in command outputs in dotted decimal format (A.B.C.D). Border Gateway Protocol IPv4 (BGPv4) | 361