Dell Force10 S4820T FTOS Command Reference Guide - Page 405

Related Commands Command History ip as-path access-list neighbor filter-list neighbor route-map Configure IP AS-Path ACL. Assign a AS-PATH list to a neighbor or peer group. Assign a route map to a neighbor or peer group. Version 7.8.1.0 Version 7.7.1.0 Version 7.6.1.0 Introduced support on S-Series Introduced support on C-Series Introduced IPv6 MGBP support for E-Series neighbor filter-list c et s Configure a BGP filter based on the AS-PATH attribute. Syntax neighbor [ip-address | peer-group-name] filter-list aspath access-list-name [in | out] To delete a BGP filter, use the no neighbor [ip-address | peer-group-name] filter-list aspath access-list-name [in | out] command. Parameters ip-address peer-group-name access-list-name in out Enter the IP address of the neighbor in dotted decimal format. Enter the name of the peer group to apply the filter to all routers in the peer group. Enter the name of an established AS-PATH access list (up to 140 characters). If the AS-PATH access list is not configured, the default is permit (to allow routes). Enter the keyword in to filter inbound BGP routes. Enter the keyword out to filter outbound BGP routes. Defaults Not configured. Command Modes ROUTER BGP Address Family (conf-router_bgp_af) Usage Information Use the ip as-path access-list command syntax in the CONFIGURATION mode to enter the AS-PATH ACL mode and configure AS-PATH filters to deny or permit BGP routes based on information in their AS-PATH attribute. Related Commands Command History ip as-path access-list Enter AS-PATH ACL mode and configure AS-PATH filters. Version 7.8.1.0 Version 7.7.1.0 Version 7.6.1.0 Introduced support on S-Series Introduced support on C-Series Introduced IPv6 MGBP support for E-Series Border Gateway Protocol IPv4 (BGPv4) | 405