Dell Force10 S4820T FTOS Command Reference Guide - Page 1274

www.dell.com | support.dell.com Related Commands router rip Enter ROUTER mode on the switch. distance c e s Assign a weight (for prioritization) to all routes in the RIP routing table or to a specific route. Lower weights ("administrative distance") are preferred. Syntax Parameters Defaults Command Modes Command History Related Commands distance weight [ip-address mask [prefix-name]] To return to the default values, use the no distance weight [ip-address mask] command. weight ip-address mask prefix-name Enter a number from 1 to 255 for the weight (for prioritization). The default is 120. (OPTIONAL) Enter the IP address, in dotted decimal format (A.B.C.D), of the host or network to receive the new distance metric. If you enter an IP address, you must also enter a mask for that IP address, in either dotted decimal format or /prefix format (/x) (OPTIONAL) Enter a configured prefix list name. weight = 120 ROUTER RIP Version 8.3.19.0 Version 8.3.7.0 Version 7.8.1.0 Version 7.6.1.0 pre-Version 6.2.1.1 Introduced on S4820T Introduced on S4810 Introduced on S-Series Introduced on C-Series Introduced on E-Series default-metric Assign one distance metric to all routes learned using the redistribute command. distribute-list in c e s Configure a filter for incoming routing updates. Syntax distribute-list prefix-list-name in [interface] To delete the filter, use the no distribute-list prefix-list-name in command. 1274 | Routing Information Protocol (RIP)