Dell Force10 S4820T FTOS Command Reference Guide - Page 890

www.dell.com | support.dell.com Table 27-3. show ip bgp neighbors Command Fields (continued) Lines beginning with Sent messages Received updates Minimum time (list of inbound and outbound policies) For address family: BGP table version accepted prefixes Prefix advertised Connections established Last reset Local host: Foreign host: Description The line displays the number of BGP messages sent, the number of notifications (error messages) and the number of messages waiting in a queue for processing. This line displays the number of BGP updates received and sent. Displays the minimum time, in seconds, between advertisements. Displays the policy commands configured and the names of the Route map, AS-PATH ACL or Prefix list configured for the policy. Displays IPv6 Unicast as the address family. Displays the which version of the primary BGP routing table the router and the neighbor are using. Displays the number of network prefixes accepted by the router and the amount of memory used to process those prefixes. Displays the number of network prefixes advertised, the number rejected and the number withdrawn from the BGP routing table. Displays the number of TCP connections established and dropped between the two peers to exchange BGP information. Displays the amount of time since the peering session was last reset. Also states if the peer resets the peering session. If the peering session was never reset, the word never is displayed. Displays the peering address of the local router and the TCP port number. Displays the peering address of the neighbor and the TCP port number. Related Commands show ip bgp ipv6 unicast View the current BGP routing table. show ip bgp ipv6 unicast peer-group c e Allows you to view information on the BGP peers in a peer group. Syntax Parameters Command Modes show ip bgp ipv6 unicast peer-group [peer-group-name [summary]] peer-group-name summary EXEC (OPTIONAL) Enter the name of a peer group to view information about that peer group only. (OPTIONAL) Enter the keyword summary to view status information of the peers in that peer group. The output is the same as that found in show ip bgp ipv6 unicast summary command 890 | IPv6 Border Gateway Protocol (IPv6 BGP)