Dell Force10 S4820T FTOS Command Reference Guide - Page 1498
debug uplink-state-group, interface, fastethernet, gigabitethernet, port-channel
View all Dell Force10 S4820T manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 1498 highlights
www.dell.com | support.dell.com Parameters Defaults Command Modes Command History Related Commands interface interface uplink-state-group group-id Specifies one or more downstream interfaces. For interface, enter one of the following interface types: Fast Ethernet: fastethernet {slot/port | slot/port-range} 1-Gigabit Ethernet: gigabitethernet {slot/port |slot/ port-range} 10-Gigabit Ethernet: tengigabitethernet {slot/port |slot/ port-range} Port channel: port-channel {1-512 | port-channel-range} Where port-range and port-channel-range specify a range of ports separated by a dash (-) and/or individual ports/port channels in any order; for example: gigabitethernet 1/1-2,5,9,11-12 port-channel 1-3,5 A comma is required to separate each port and port-range entry. Re-enables all UFD-disabled downstream interfaces in the group. Valid group-id values are 1 to 16. A downstream interface in an uplink-state group that has been disabled by UFD is disabled and in a UFD-disabled error state. CONFIGURATION Version 8.3.19.0 Version 8.3.12.0 Version 8.4.2.3 Introduced on S4820T Introduced on S4810 Introduced on the S-Series S50. downstream uplink-state-group Assign a port or port-channel to the uplink-state group as a downstream interface. Create an uplink-state group and enabling the tracking of upstream links. debug uplink-state-group s S50 only Enable debug messages for events related to a specified uplink-state group or all groups. Syntax Parameters Defaults Command Modes debug uplink-state-group [group-id] group-id None Enables debugging on the specified uplink-state group. Valid group-id values are 1 to 16. EXEC Privilege 1498 | Uplink Failure Detection (UFD)