Dell Force10 S4820T FTOS Command Reference Guide - Page 961

Command History Version 8.3.19.0 Version 8.3.12.0 Version 8.5.1.0 Version 8.3.7.0 Version 7.6.1.0 Version 7.5.1.0 pre-Version 6.1.1.1 Introduced on S4820T. Added support for sticky MAC addresses. Added support for 4-port 40G line cards on ExaScale. Introduced on S4810 Introduced on S-Series Introduced on C-Series Introduced on E-Series mac accounting destination e Configure a destination counter for Layer 2 traffic. Syntax mac accounting destination {mac-address vlan vlan-id | vlan} [bytes | packets] To delete a destination counter, enter no mac accounting destination. Parameters mac-address vlan vlan-id bytes packets Enter the MAC address in the nn:nn:nn:nn:nn:nn format to count Layer 2 packets or bytes sent to that MAC address. Enter the keyword vlan followed by the VLAN ID to count Layer 2 packets or bytes sent to the VLAN. Range: 1 to 4094. (OPTIONAL) Enter the keyword bytes to count only bytes (OPTIONAL) Enter the keyword packets to count only packets. Defaults Not configured. Command Modes INTERFACE (available on physical interfaces only) Command History Usage Information Version 7.4.1.0 Introduced on E-Series You must place the interface in Layer 2 mode (using the switchport command) prior to configuring the mac accounting destination command. mac-address-table aging-time c e s Specify an aging time for MAC addresses to be removed from the MAC Address Table. Syntax mac-address-table aging-time seconds Layer 2 | 961