Dell Force10 S4820T FTOS Command Reference Guide - Page 693

Parameters Defaults Command Modes Command History Usage Information Related Commands name Enter a domain name to be used to complete unqualified names (that is, incomplete domain names that cannot be resolved). Disabled. CONFIGURATION Version 8.3.19.0 Version 8.3.7.0 Version 8.1.1.0 Version 7.6.1.0 Version 7.5.1.0 Introduced on S4820T Introduced on S4810 Introduced on E-Series ExaScale Introduced on S-Series Introduced on C-Series Configure the ip domain-list command up to 6 times to configure a list of possible domain names. If both the ip domain-name and ip domain-list commands are configured, the software will try to resolve the name using the ip domain-name command. If the name is not resolved, the software goes through the list of names configured with the ip domain-list command to find a match. Use the following steps to enable dynamic resolution of hosts: • specify a domain name server with the ip name-server command. • enable DNS with the ip domain-lookup command. To view current bindings, use the show hosts command. To view DNS related configuration, use the show running-config resolve command. ip domain-name Specify a DNS server. ip domain-lookup c e s Enable dynamic host-name to address resolution (that is, DNS). Syntax Defaults Command Mode ip domain-lookup To disable DNS lookup, use the no ip domain-lookup. Disabled. CONFIGURATION IPv4 Routing | 693