Dell Force10 S4820T FTOS Command Reference Guide - Page 830

www.dell.com | support.dell.com Parameters Defaults Command Modes Command History Usage Information Related Commands ipv6-address peer-group-name Disabled ROUTER BGP Enter the IPv6 address in the x:x:x:x::x format. The :: notation specifies successive hexadecimal fields of zeros. Enter the name of the peer group. Version 8.3.19.0 Version 8.4.2.1 Version 8.2.1.0 Version 7.4.1.0 Introduced on S4820T Introduced on C-Series and S4810 Introduced on E-Series ExaScale Introduced on E-Series TeraScale When fall-over is enabled, BGP keeps track of IP or IPv6 reachability to the peer remote address and the peer local address. Whenever either address becomes unreachable (i.e, no active route exists in the routing table for peer IP or IPv6 destination/local address), BGP brings down the session with the peer. show ip bgp ipv6 unicast neighbors Display IPv6 routing information exchanged by BGP neighbors. neighbor filter-list c e Configure a BGP filter based on the AS-PATH attribute. Syntax Parameters Defaults Command Modes neighbor {ipv6-address | peer-group-name} filter-list as-path-name {in | out} To delete a BGP filter, use the no neighbor {ipv6-address | peer-group-name} filter-list as-path-name {in | out} command. ipv6-address peer-group-name as-path-name in out Enter the IPv6 address in the x:x:x:x::x format. The :: notation specifies successive hexadecimal fields of zeros. Enter the name of the peer group to apply the filter to all routers in the peer group. Enter the name of an established AS-PATH access list. If the AS-PATH access list is not configured, the default is permit (to allow routes). (16 characters maximum) Enter the keyword in to filter inbound BGP routes. Enter the keyword out to filter outbound BGP routes. Not configured. ROUTER BGPV6-ADDRESS FAMILY 830 | IPv6 Border Gateway Protocol (IPv6 BGP)