Dell Force10 S4820T FTOS Command Reference Guide - Page 629

Usage Information FTOS(conf-if-vl-20)# The example above sets a port as hybrid, makes the port a tagged member of VLAN 20, and an untagged member of VLAN 10, which becomes the native VLAN of the port. The port will now accept: Example (Tagged Hybrid Interface) • untagged frames and classify them as VLAN 10 frames • VLAN 20 tagged frames The next example shows output with "Hybrid" as the newly added value for 802.1QTagged. The options for this field are: • True-port is tagged • False-port is untagged • Hybrid-port accepts both tagged and untagged frames FTOS(conf-if-vl-20)#do show interfaces switchport Name: GigabitEthernet 7/0 802.1QTagged: Hybrid Vlan membership: Vlan 10, Vlan 20 Native VlanId: 10 FTOS(conf-if-vl-20)# Example (Removing Hybrid port configuration) The text below is an example unconfiguration of the hybrid port using the no portmode hybrid command. Note: You must remove all other configurations on the port before you can remove the hybrid configuration from the port. Related Commands FTOS(conf-if-vl-20)#interface vlan 10 FTOS(conf-if-vl-10)#no untagged gi 7/0 FTOS(conf-if-vl-10)#interface vlan 20 FTOS(conf-if-vl-20)#no tagged gi 7/0 FTOS(conf-if-vl-20)#interface gi 7/0 FTOS(conf-if-gi-7/0)#no portmode hybrid FTOS(conf-if-vl-20)# show interfaces switchport switchport vlan-stack trunk Display the configuration of switchport (Layer 2) interfaces on the switch. Place the interface in a Layer 2 mode. Specify an interface as a trunk port to the Stackable VLAN network. rate-interval c e s Configure the traffic sampling interval on the selected interface. Syntax rate-interval seconds Interfaces | 629