Dell Force10 S4820T FTOS Command Reference Guide - Page 800
bgp client-to-client reflection, bgp cluster-id
View all Dell Force10 S4820T manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 800 highlights
www.dell.com | support.dell.com bgp client-to-client reflection c e Allows you to enable route reflection between clients in a cluster. Syntax Defaults Command Modes Command History Usage Information Related Commands bgp client-to-client reflection To disable client-to-client reflection, enter no bgp client-to-client reflection. Enabled when a route reflector is configured. ROUTER BGP Version 8.3.19.0 Version 8.4.2.1 Version 8.2.1.0 Version 7.4.1.0 Introduced on S4820T Introduced on C-Series and S4810 Introduced on E-Series ExaScale Introduced on E-Series TeraScale Route reflection to clients is not necessary if all client routers are fully meshed. bgp cluster-id Assign ID to a BGP cluster with two or more route reflectors. neighbor route-reflector-client Configure a route reflector and clients. bgp cluster-id c e Assign a cluster ID to a BGP cluster with more than one route reflector. Syntax Parameters Defaults Command Modes Command History bgp cluster-id {ip-address | number} To delete a cluster ID, use the no bgp cluster-id {ip-address | number} command. ip-address number Enter an IP address as the route reflector cluster ID. Enter a route reflector cluster ID as a number from 1 to 4294967295. Not configured. ROUTER BGP Version 8.3.19.0 Version 8.4.2.1 Version 8.2.1.0 Version 7.4.1.0 Introduced on S4820T Introduced on C-Series and S4810 Introduced on E-Series ExaScale Introduced on E-Series TeraScale 800 | IPv6 Border Gateway Protocol (IPv6 BGP)