Dell Force10 S4820T FTOS Command Reference Guide - Page 28
Multiple Spanning Tree Mode, Protocol Gvrp Mode, Router Ospf Mode
View all Dell Force10 S4820T manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 28 highlights
www.dell.com | support.dell.com 28 | CLI Basics MULTIPLE SPANNING TREE Mode Use MULTIPLE SPANNING TREE mode to enable and configure the Multiple Spanning Tree protocol, as described in Chapter 34, Multiple Spanning Tree Protocol (MSTP). To enter MULTIPLE SPANNING TREE mode: 1. Verify that you are logged into the CONFIGURATION mode. 2. Enter the protocol spanning-tree mstp command. You can return to the CONFIGURATION mode by entering the exit command. PROTOCOL GVRP Mode Use the PROTOCOL GVRP mode to enable and configure GARP VLAN Registration Protocol (GVRP), as described in Chapter 19, GARP VLAN Registration (GVRP). To enter PROTOCOL GVRP mode: 1. Verify that you are logged into the CONFIGURATION mode. 2. Enter the protocol gvrp command syntax. You can return to the CONFIGURATION mode by entering the exit command. ROUTER OSPF Mode Use the ROUTER OSPF mode to configure OSPF, as described in Chapter 37, Open Shortest Path First (OSPFv2). To enter ROUTER OSPF mode: 1. Verify that you are logged into the CONFIGURATION mode. 2. Use the router ospf {process-id} command.The prompt changes to include (conf-router_ospf-id). You can switch to the INTERFACE mode by using the interface command or you can switch to the ROUTER RIP mode by using the router rip command. ROUTER RIP Mode Use the ROUTER RIP mode to configure RIP on the C-Series or E-Series, as described in Chapter 43, Routing Information Protocol (RIP). To enter ROUTER RIP mode: