Dell Force10 S4820T FTOS Command Reference Guide - Page 233

Command Modes Command History Usage Information CONFIGURATION-EXTENDED-ACCESS-LIST Version 8.2.1.0 Version 8.1.1.0 Version 7.4.1.0 Version 6.5.10 Allows ACL control of fragmented packets for IP (Layer 3) ACLs. Introduced on E-Series ExaScale Added monitor option Expanded to include the optional QoS order priority for the ACL entry. The monitor option is relevant in the context of the flow-based monitoring feature only. Refer to the Port Monitoring chapter. When you use the log option, CP processor logs details about the packets that match. Depending on how many packets match the log entry and at what rate, the CP may become busy as it has to log these packets' details. The order option is relevant in the context of the Policy QoS feature only. The following applies: • The seq sequence-number is applicable only in an ACL group. • The order option works across ACL groups that have been applied on an interface via QoS policy framework. • The order option takes precedence over the seq sequence-number. • If sequence-number is not configured, then rules with the same order value are ordered according to their configuration order. • If the sequence-number is configured, then the sequence-number is used as a tie breaker for rules with the same order. Note: When ACL logging and byte counters are configured simultaneously, byte counters may display an incorrect value. Configure packet counters with logging instead. You cannot include IP, TCP or UDP (Layer 3) filters in an ACL configured with ARP or Ether-type (Layer 2) filters. Apply Layer 2 ACLs to interfaces in Layer 2 mode. seq ether-type e Configure an egress filter with a specific sequence number that filters traffic with specified types of Ethernet packets. This command is supported only on 12-port GE line cards with SFP optics; refer to your line card documentation for specifications. Syntax seq sequence-number {deny | permit} ether-type protocol-type-number {destination-mac-address mac-address-mask | any} vlan vlan-id {source-mac-address mac-address-mask | any} [count [byte] | log] [order] [monitor] Parameters sequence-number deny Enter a number from 0 to 4294967290. Enter the keyword deny to drop all traffic meeting the filter criteria. Access Control Lists (ACL) | 233