Dell Force10 S4820T FTOS Command Reference Guide - Page 1544

www.dell.com | support.dell.com Parameters Defaults Command Modes Command History Usage Information ip-address1 ... ip-address12 Enter an IP address of the virtual router in dotted decimal format. The IP address must be on the same subnet as the interface's primary IP address. (OPTIONAL) Enter up to 11 additional IP addresses of virtual routers in dotted decimal format. Separate the IP addresses with a space. The IP addresses must be on the same subnet as the interface's primary IP address. Not configured. VRRP Version 8.3.19.0 Version 8.3.7.0 Version 7.6.1.0 Version 7.5.1.0 Version 7.4.1.0 pre-Version 6.2.1.1 Introduced on S4820T Introduced on S4810 Introduced on S-Series Introduced on C-Series Introduced support for telnetting to the VRRP group IP address assigned using this command Introduced on E-Series The VRRP group only becomes active and sends VRRP packets when a virtual IP address is configured. When you delete the virtual address, the VRRP group stops sending VRRP packets. A system message appears after you enter or delete the virtual-address command. To guarantee that a VRRP group becomes MASTER, configure the VRRP group's virtual address with the same IP address as the interface's primary IP address and change the priority of the VRRP group to 255. You can ping the virtual addresses configured in all VRRP groups. vrrp delay minimum Set the delay time for VRRP initialization after an interface comes up. Syntax Parameters Defaults vrrp delay minimum seconds seconds 0 Enter the number of seconds for the delay for VRRP initialization after an interface becomes operational. Range: 0 to 900 (0 indicates no delay) 1544 | Virtual Router Redundancy Protocol (VRRP)