Dell Force10 S4820T FTOS Command Reference Guide - Page 637

Usage Information LineSpeed 10 Mbit, Mode half duplex ARP type: ARPA, ARP Timeout 04:00:00 Last clearing of "show interface" counters 04:01:08 Queueing strategy: fifo Input 943 packets, 78347 bytes, 190 multicast Received 0 errors, 0 discarded Output 459 packets, 102388 bytes, 15 multicast Output 0 errors, 0 invalid protocol Time since last interface status change: 00:03:09 On the C-Series and S-Series, the interface counter "over 1023-byte pkts" does not increment for packets in the range 9216 > x < 1023. The Management port is enabled by default (no shutdown). If necessary, use the ip address command to assign an IP address to the Management port. If two RPMs are installed in your system, use the show redundancy command to display which RPM is the Primary RPM. Related Commands show interfaces configured show interfaces linecard show interfaces phy show interfaces rate show interfaces switchport show inventory (C-Series and E-Series) show inventory (S-Series) show ip interface show linecard show range Display any interface with a non-default configuration. Display information on all interfaces on a specific line card. Display information of either rate limiting or rate policing on the interface. Display Layer 2 information about the interfaces. Display the chassis type, components (including media), FTOS version including hardware identification numbers and configured protocols. Display the S-Series switch type, components (including media), FTOS version including hardware identification numbers and configured protocols. Display Layer 3 information about the interfaces. Display the line card(s) status. Display all interfaces configured using the interface range command. show interfaces configured c e s Display any interface with a non-default configuration. Syntax show interfaces configured Command Modes EXEC EXEC Privilege Command History Version 8.3.19.0 Introduced on S4820T Version 8.3.7.0 Introduced on S4810 Interfaces | 637