Dell Force10 S4820T FTOS Command Reference Guide - Page 655
speed for 10/100/1000 interfaces
View all Dell Force10 S4820T manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 655 highlights
Related Commands interface port-channel interface vlan show ip interface Create a port channel interface. Create a VLAN. Displays the interface routing status. Add the keyword brief to display a table of interfaces and their status. speed (for 10/100/1000 interfaces) c e s Set the speed for 10/100/1000 Base-T Ethernet interfaces. Both sides of a link must be set to the same speed (10/100/1000) or to auto or the link may not come up. Syntax speed {10 | 100 | 1000 | auto} To return to the default setting, use the no speed {10 | 100 | 1000} command. Parameters 10 100 1000 auto Enter the keyword 10 to set the interface's speed to 10 Mb/s. Note: This interface speed is not supported on the LC-EH-GE-50P or the LC-EJ-GE-50P card. If the command is entered for these interfaces, an error message appears. Enter the keyword 100 to set the interface's speed to 10/100 Mb/s. Note: When this setting is enabled, only 100Base-FX optics are supported on the LC-EH-GE-50P or the LC-EJ-GE-50P card. Enter the keyword 1000 to set the interface's speed to 1000 Mb/s. (Auto-negotiation is enabled. Refer to negotiation auto for more information) When this setting is enabled, only 100oBase-FX optics are supported on the LC-EH-GE-50P or the LC-EJ-GE-50P card. Enter the keyword auto to set the interface to auto-negotiate its speed. (Auto-negotiation is enabled. Refer to negotiation auto for more information) Defaults Command Modes auto INTERFACE Command History Version 8.3.19.0 Version 8.3.7.0 Version 8.3.1.0 Version 8.1.1.0 Version 7.6.1.0 Version 7.5.1.0 E-Series legacy command Introduced on S4820T Introduced on S4810 Supported on LC-EH-GE-50P or the LC-EJ-GE-50P cards Introduced on E-Series ExaScale Introduced on S-Series Introduced on C-Series Usage Information This command is found on the 10/100/1000 Base-T Ethernet interfaces. When auto is enabled, the system performs and automatic discovery to determine the optics installed and configure the appropriate speed. Interfaces | 655