Dell Force10 S4820T FTOS Command Reference Guide - Page 1276

www.dell.com | support.dell.com Parameters Defaults Command Modes Command History Related Commands prefix-list-name interface connected isis ospf static Enter the name of a configured prefix list. (OPTIONAL) Identifies the interface type slot/port as one of the following: • For a 1-Gigabit Ethernet interface, enter the keyword GigabitEthernet followed by the slot/port information. • For a Port Channel interface, enter the keyword port-channel followed by a number: C-Series and S-Series Range: 1 to 128 E-Series Range: 1 to 32 for EtherScale, 1 to 255 for TeraScale and 1 to 512 for ExaScale. • For a SONET interface, enter the keyword sonet followed by the slot/ port information. • For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet followed by the slot/port information. • For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE followed by the slot/port information. • For a VLAN, enter the keyword vlan followed by a number from 1 to 4094. (OPTIONAL) Enter the keyword connected to filter only directly connected routes. (OPTIONAL) Enter the keyword isis to filter only IS-IS routes. Note: This option is only available on E-Series. (OPTIONAL) Enter the keyword ospf to filter all OSPF routes. (OPTIONAL) Enter the keyword static to filter manually configured routes. Not configured. ROUTER RIP Version 8.3.19.0 Version 8.5.1.0 Version 8.3.7.0 Version 7.8.1.0 Version 7.6.1.0 pre-Version 6.2.1.1 Introduced on S4820T Added support for 4-port 40G line cards on ExaScale. Introduced on S4810 Introduced on S-Series Introduced on C-Series Introduced on E-Series ip prefix-list Enter the PREFIX-LIST mode and configure a prefix list. ip poison-reverse c e s Set the prefix of the RIP routing updates to the RIP infinity value. Syntax ip poison-reverse To disable poison reverse, enter no ip poison-reverse. 1276 | Routing Information Protocol (RIP)