Dell Force10 S4820T FTOS Command Reference Guide - Page 844
reachable via non-BGP routes and non-default routes., Specify this IGP route as the preferred route.
View all Dell Force10 S4820T manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 844 highlights
www.dell.com | support.dell.com Parameters Defaults Command Modes Command History Usage Information Related Commands To remove a network, use the no network ip-address mask [route-map map-name] command. ipv6-address prefix-length mask route-map map-name Enter the IPv6 address in the x:x:x:x::x format followed by the prefix length in the /x format. Range: /0 to /128 The :: notation specifies successive hexadecimal fields of zeros. Enter the mask of the IP address in the slash prefix length format (for example, /24). The mask appears in command outputs in dotted decimal format (A.B.C.D). (OPTIONAL) Enter the keyword route-map followed by the name of an established route map. Only the following ROUTE-MAP mode commands are supported: • match ipv6 address • match ipv6 next-hop • match ipv6 route-source • set ipv6 next-hop If the route map is not configured, the default is deny (to drop all routes). Not configured. ROUTER BGPV6-ADDRESS FAMILY Version 8.3.19.0 Version 8.4.2.1 Version 8.2.1.0 Version 7.4.1.0 Introduced on S4820T Introduced on C-Series and S4810 Introduced on E-Series ExaScale Introduced on E-Series TeraScale The E-Series software resolves the network address configured by the network command with the routes in the main routing table to ensure that the networks are reachable via non-BGP routes and non-default routes. redistribute Redistribute routes into BGP. network backdoor c e Specify this IGP route as the preferred route. Syntax network ipv6-address prefix-length backdoor To remove a network, use the no network ipv6-address prefix-length backdoor command. 844 | IPv6 Border Gateway Protocol (IPv6 BGP)