Dell Force10 S4820T FTOS Command Reference Guide - Page 878

www.dell.com | support.dell.com Defaults Command Modes Command History Usage Information map-name in out Enter the name of an established route map. If the Route map is not configured, the default is deny (to drop all routes). Enter the keyword in to filter inbound routes. Enter the keyword out to filter outbound routes. Not configured. ROUTER BGPV6-ADDRESS FAMILY Version 8.3.19.0 Version 8.4.2.1 Version 7.4.1.0 Introduced on S4820T Introduced on C-Series and S4810 Introduced on E-Series TeraScale When you apply a route map to outbound routes, only routes that match at least one section of the route map are permitted. If you identify a peer group by name, the peers in that peer group inherit the characteristics in the Route map used in this command. If you identify a peer by IP address, the Route map overwrites either the inbound or outbound policies on that peer. neighbor route-reflector-client c e Configure a neighbor as a member of a route reflector cluster. Syntax Parameters Defaults Command Modes Command History neighbor ipv6-address| peer-group-name route-reflector-client To indicate that the neighbor is not a route reflector client or to delete a route reflector configuration, use the no neighbor ipv6-address | peer-group-name route-reflector-client command. ipv6-address peer-group-name (OPTIONAL) Enter the IPv6 address in the x:x:x:x::x format. The :: notation specifies successive hexadecimal fields of zeros. (OPTIONAL) Enter the name of the peer group. All routers in the peer group receive routes from a route reflector. Not configured. ROUTER BGPV6-ADDRESS FAMILY Version 8.3.19.0 Version 8.4.2.1 Version 7.4.1.0 Introduced on S4820T Introduced on C-Series and S4810 Introduced on E-Series TeraScale 878 | IPv6 Border Gateway Protocol (IPv6 BGP)