Dell Force10 S4820T FTOS Command Reference Guide - Page 778
ipv6 route
View all Dell Force10 S4820T manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 778 highlights
www.dell.com | support.dell.com Usage Information By default, all prefixes configured as addresses on the interface are advertised. This command allows control over the individual parameters per prefix; the default keyword can be used to use the default parameters for all prefixes. If a prefix has been configured with lifetime parameter values, the default values cannot be applied using the ipv6 nd prefix default no-autoconfig command. ipv6 route c e s Establish a static IPv6 route. Syntax ipv6 route ipv6-address prefix-length {ipv6-address | interface | interface ipv6-address} [distance] [tag value] [permanent] To remove the IPv6 route, use the no ipv6 route ipv6-address prefix-length {ipv6-address | interface | interface ipv6-address} [distance] [tag value] [permanent] command. Parameters ipv6-address prefix-length interface ipv6-address distance tag value Enter the IPv6 address in the x:x:x:x::x format followed by the prefix length in the /x format. Range: /0 to /128 Note: The :: notation specifies successive hexadecimal fields of zeros (OPTIONAL) Enter the following keywords and slot/port or number information: • For a 1-Gigabit Ethernet interface, enter the keyword GigabitEthernet followed by the slot/port information. • For a loopback interface, enter the keyword loopback followed by a number from zero (0) to 16383. • For the null interface, enter the keyword null followed by zero (0). • For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet followed by the slot/port information. • For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE followed by the slot/port information. • For a VLAN interface, enter the keyword VLAN followed by the vlan number. • For a port channel interface, enter the keyword port-channel followed by the port channel number. If you configure a static IPv6 route using an egress interface and enter the ping command to reach the destination IPv6 address, the ping operation may not work. Configure the IPv6 route using a next-hop IPv6 address in order for the ping command to detect the destination address. (OPTIONAL) Enter the forwarding router IPv6 address in the x:x:x:x::x format. Note: The :: notation specifies successive hexadecimal fields of zeros (OPTIONAL) Enter a number as the metric distance assigned to the route. Range: 1 to 255 (OPTIONAL) Enter the keyword tag followed by a tag value number. Range: 1 to 4294967295 778 | IPv6 Basics