Dell Force10 S4820T FTOS Command Reference Guide - Page 824

www.dell.com | support.dell.com Defaults Command Modes Command History internal-distance local-distance Enter a number to assign to routes learned from a router within the AS. Range: 1 to 255. Default: 200 Enter a number to assign to routes learned from networks listed in the network command. Range: 1 to 255. Default: 200 external-distance = 20; internal-distance = 200; local-distance = 200. ROUTER BGPV6-ADDRESS FAMILY Version 8.3.19.0 Version 8.4.2.1 Version 8.2.1.0 Version 7.4.1.0 Introduced on S4820T Introduced on C-Series and S4810 Introduced on E-Series ExaScale Introduced on E-Series TeraScale Caution: Dell Force10 recommends that you do not change the administrative distance of internal routes. Changing the administrative distances may cause routing table inconsistencies. Usage Information The higher the administrative distance assigned to a route means that your confidence in that route is low. Routes assigned an administrative distance of 255 are not installed in the routing table. Routes from confederations are treated as internal BGP routes. maximum-paths c e Configure the maximum number of parallel routes (multipath support) BGP supports. Syntax Parameters Defaults Command Modes maximum-paths {ebgp | ibgp} number To return to the default values, enter no maximum-paths. ebgp ibgp number Enter the keyword ebgp to enable multipath support for External BGP routes. Enter the keyword ibgp to enable multipath support for Internal BGP routes. Enter a number as the maximum number of parallel paths. Range: 1 to 16 Default: 1 1 ROUTER BGPV6-ADDRESS FAMILY 824 | IPv6 Border Gateway Protocol (IPv6 BGP)