Dell Force10 S4820T FTOS Command Reference Guide - Page 820

www.dell.com | support.dell.com Defaults Command Modes Usage Information Command History Disabled EXEC Privilege This command turns on BGP soft-reconfiguration inbound debugging for IPv6 unicast routes. If no neighbor is specified, debug is turned on for all neighbors. Version 8.3.19.0 Version 8.4.1.0 Version 7.8.1.0 Version 7.7.1.0 Version 7.2.1.0 Introduced on S4820T Added support for IPv4 multicast and IPv6 unicast routes Introduced support on S4810 Introduced support on C-Series Introduced on the E-Series TeraScale debug ip bgp keepalives c e Allows you to view information about BGP keepalive messages. Syntax Parameters Command Modes Command History Usage Information debug ip bgp [ipv6-address | peer-group peer-group-name] keepalives [in | out] To disable debugging, use the no debug ip bgp [ip-address | peer-group peer-group-name] keepalives [in | out] command. ipv6-address peer-group peer-group-name in out (OPTIONAL) Enter the IPv6 address in the x:x:x:x::x format followed by the prefix length in the /x format. Range: /0 to /128 The :: notation specifies successive hexadecimal fields of zeros. (OPTIONAL) Enter the keyword peer-group followed by the name of the peer group. (OPTIONAL) Enter the keyword in to view only inbound keepalive messages. (OPTIONAL) Enter the keyword out to view only outbound keepalive messages. EXEC Privilege Version 8.3.19.0 Version 8.4.2.1 Version 8.2.1.0 Version 7.4.1.0 Introduced on S4820T Introduced on C-Series and S4810 Introduced on E-Series ExaScale Introduced on E-Series TeraScale Enter the no debug ip bgp command to remove all configured debug commands for BGP. 820 | IPv6 Border Gateway Protocol (IPv6 BGP)