Dell Force10 S4820T FTOS Command Reference Guide - Page 686

www.dell.com | support.dell.com Parameters Command Modes Command History Defaults Usage Information interface count value (OPTIONAL) Enter the following keywords and slot/port or number information: • For a 1-Gigabit Ethernet interface, enter the keyword gigabitethernet followed by the slot/port information. • For the Management interface, enter the keyword managementethernet followed by the slot/port information. The slot range is 0-1 and the port range is 0. • For a Port Channel interface, enter the keyword port-channel followed by a number: C-Series and S-Series Range: 1-128 E-Series Range: 1 to 32 for EtherScale, 1 to 255 for TeraScale and 1 to 512 for ExaScale. • For a SONET interface, enter the keyword sonet followed by the slot/port information. • For a 10-Gigabit Ethernet interface, enter the keyword tengigabitethernet followed by the slot/port information. • For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE followed by the slot/port information. • For a VLAN, enter the keyword vlan followed by a number from 1 to 4094. (OPTIONAL) Enter the keyword count followed by the count value. Range: 1 to 65534 EXEC Privilege Version 8.3.19.0 Version 8.5.1.0 Version 8.3.7.0 Version 8.2.1.0 Version 8.1.1.0 Version 7.6.1.0 Version 7.5.1.0 Version 6.3.1.0 Introduced on S4820T Added support for 4-port 40G line cards on ExaScale. Introduced on S4810 Support 4094 VLANs on E-Series ExaScale (prior limit was 2094) Introduced on E-Series ExaScale Introduced on S-Series Introduced on C-Series Added the count option No default behavior or values Use the count option to stop packets from flooding the user terminal when debugging is turned on. debug ip dhcp c e s Enable debug information for DHCP relay transactions and display the information on the console. Syntax debug ip dhcp To disable debug, use the no debug ip dhcp command. 686 | IPv4 Routing