Dell Force10 S4820T FTOS Command Reference Guide - Page 616
cannot create virtual interfaces VLAN, Port-channel using the, command.
View all Dell Force10 S4820T manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 616 highlights
www.dell.com | support.dell.com Example (Bulk Configuration Warning message) Example (Interface Range prompt with multiple ports) Example (Interface Range prompt with overlapping port ranges) • If overlapping port ranges are specified, the port range is extended to the smallest start port and the biggest end port. FTOS(conf)#interface range so 2/0 - 1 , te 10/0 , gi 3/0 , fa 0/0 % Warning: Non-existing ports (not configured) are ignored by interface-range FTOS(conf)#interface range gi 2/0 - 23 , gi 2/1 - 10 FTOS(conf-if-range-gi-2/0-23# FTOS(conf)#interface range gi 2/1 - 11 , gi 2/1 - 23 FTOS(conf-if-range-gi-2/1-23# Only VLAN and port-channel interfaces created using the interface vlan and interface port-channel commands can be used in the interface range command. Use the show running-config command to display the VLAN and port-channel interfaces. VLAN or port-channel interfaces that are not displayed in the show running-config command can not be used with the bulk configuration feature of the interface range command. You cannot create virtual interfaces (VLAN, Port-channel) using the interface range command. Note: If a range has VLAN, physical, port-channel, and SONET interfaces, only commands related to physical interfaces can be bulk configured. To configure commands specific to VLAN, port-channel or SONET, only those respective interfaces should be configured in a particular range. Example (Single Range Bulk Configuration) Example (Multiple Range Bulk Configuration Gigabit Ethernet & Ten Gigabit Ethernet) Example (Multiple Range Bulk Configuration with SONET, VLAN, and port channel) Related Commands The following text is an example of a single range bulk configuration. FTOS(config)# interface range gigabitethernet 5/1 - 23 FTOS(config-if-range)# no shutdown FTOS(config-if-range)# The following example shows how to use commas to add different interface types to the range enabling all Gigabit Ethernet interfaces in the range 5/1 to 5/23 and both Ten Gigabit Ethernet interfaces 1/1 and 1/2. FTOS(config-if)# interface range gigabitethernet 5/1 - 23, tengigabitethernet 1/1 - 2 FTOS(config-if-range)# no shutdown FTOS(config-if-range)# The following figure shows how to use commas to add SONET, VLAN, and port-channel interfaces to the range. FTOS(config-if)# interface range gigabitethernet 5/1 - 23, tengigabitethernet 1/1 - 2, Vlan 2 - 100 , Port 1 - 25 FTOS(config-if-range)# no shutdown FTOS(config-if-range)# interface port-channel interface vlan Configure a port channel group. Configure a VLAN interface. 616 | Interfaces