Dell Force10 S4820T FTOS Command Reference Guide - Page 991

untagged c e s Add a Layer 2 interface to a VLAN as an untagged interface. Syntax Parameters Defaults Command Modes Command History Usage Information Related Commands untagged interface To remove an untagged interface from a VLAN, use the no untagged interface command. interface Enter the following keywords and slot/port or number information: • For a 1-Gigabit Ethernet interface, enter the keyword GigabitEthernet followed by the slot/port information. • For a Port Channel interface, enter the keyword port-channel followed by a number: C-Series and S-Series Range: 1-128 E-Series Range: 1 to 255 for TeraScale and 1 to 512 for ExaScale. • For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet followed by the slot/port information. • For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE followed by the slot/port information. All interfaces in Layer 2 mode are untagged. INTERFACE VLAN Version 8.3.19.0 Version 8.5.1.0 Version 8.3.7.0 Version 7.6.1.0 Version 7.5.1.0 pre-Version 6.2.1.1 Introduced on S4820T. Added support for 4-port 40G line cards on ExaScale. Introduced on S4810 Introduced on S-Series Introduced on C-Series Introduced on E-Series Untagged interfaces can only belong to one VLAN. In the Default VLAN, you cannot use the no untagged interface command. To remove an untagged interface from all VLANs, including the Default VLAN, enter the INTERFACE mode and use the no switchport command. interface vlan tagged Configure a VLAN. Specify which interfaces in a VLAN are tagged. Layer 2 | 991