Dell Force10 S4820T FTOS Command Reference Guide - Page 906

www.dell.com | support.dell.com clns host e Define a name-to-network service mapping point (NSAP) mapping that can then be used with commands that require NSAPs and system IDs. Syntax clns host name nsap Parameters name nsap Enter an alphanumeric string to identify the name-to-NSAP mapping. Enter a specific NSAP address that will be associated with the name parameter. Defaults Not configured. Command Modes ROUTER ISIS Command History Version 8.3.19.0 Version 8.3.12.0 Introduced on S4820T Introduced on S4810 Related Commands hostname dynamic Enables dynamic learning of hostnames from routers in the domain and allows the routers to advertise the hostnames in LSPs. Usage Information Use this command to configure a shortcut name that can used instead of entering a long string of numbers associated with an NSAP address. debug isis e Enable debugging for all IS-IS operations. Syntax debug isis To disable debugging of IS-IS, enter no debug isis. Command Modes EXEC Privilege Command History Version 8.3.19.0 Version 8.3.12.0 Introduced on S4820T Introduced on S4810 Usage Information Entering debug isis enables all debugging parameters. Use this command to display all debugging information in one output. To turn off debugging, you normally enter separate no forms of each command. Enter the no debug isis command to disable all debug messages for IS-IS at once. 906 | Intermediate System to Intermediate System (IS-IS)