Dell Force10 S4820T FTOS Command Reference Guide - Page 765
IPv6 Route Map Commands
View all Dell Force10 S4820T manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 765 highlights
Example (C-Series) The following example shows the output shown when using the test cam-usage command. FTOS#test cam-usage service-policy input LauraMapTest linecard all Linecard | Portpipe | CAM Partition | Available CAM | Estimated CAM per Port | Status 2 | 1 | IPv4Flow | 232 | 0 | Allowed 2 | 1 | IPv6Flow | 0 | 0 | Allowed 4 | 0 | IPv4Flow | 232 | 0 | Allowed 4 | 0 | IPv6Flow | 0 | 0 | Allowed FTOS# FTOS#test cam-usage service-policy input LauraMapTest linecard 4 port-set 0 Linecard | Portpipe | CAM Partition | Available CAM | Estimated CAM per Port | Status 4 | 0 | IPv4Flow | 232 | 0 | Allowed 4 | 0 | IPv6Flow | 0 | 0 | Allowed FTOS# FTOS#test cam-usage service-policy input LauraMapTest linecard 2 port-set 1 Linecard | Portpipe | CAM Partition | Available CAM | Estimated CAM per Port | Status 2 | 1 | IPv4Flow | 232 | 0 | Allowed 2 | 1 | IPv6Flow | 0 | 0 | Allowed FTOS#) Table 25-3. Output Explanations: test cam-usage Term Linecard Portpipe CAM Partition Available CAM Estimated CAM per Port Status Explanation Lists the line card or linecards that are checked. Entering all shows the status for linecards in the chassis Lists the portpipe (port-set) or port pipes (port-sets) that are checked. Entering all shows the status for linecards and port-pipes in the chassis. Shows the CAM profile of the CAM Identifies the amount of CAM space remaining for that profile Estimates the amount of CAM space the listed policy will require. Indicates whether or not the policy will be allowed in the CAM IPv6 Route Map Commands The following commands allow you to configure route maps and their redistribution criteria. • match ipv6 address • match ipv6 next-hop IPv6 Access Control Lists (IPv6 ACLs) | 765