Dell Force10 S4820T FTOS Command Reference Guide - Page 403

Defaults Command Modes Usage Information Related Commands Command History Disabled ROUTER BGP Address Family (conf-router_bgp_af) By default, when a neighbor/peer group configuration is created in the Router BGP context, it is enabled for the IPv4/Unicast AFI/SAFI. By using activate in the new context, the neighbor/peer group is enabled for AFI/SAFI. address family ipv4 multicast (MBGP) Changes the context to SAFI Version 7.8.1.0 Version 7.7.1.0 Version 7.6.1.0 Introduced support on S-Series Introduced support on C-Series Introduced IPv6 MGBP support for E-Series neighbor advertisement-interval c et s Set the advertisement interval between BGP neighbors or within a BGP peer group. Syntax neighbor {ip-address | peer-group-name} advertisement-interval seconds To return to the default value, use the no neighbor {ip-address | peer-group-name} advertisement-interval command. Parameters ip-address peer-group-name seconds Enter the IP address of the neighbor in dotted decimal format. Enter the name of the peer group to set the advertisement interval for all routers in the peer group. Enter a number as the time interval, in seconds, between BGP advertisements. Range: 0 to 600 seconds. Default: 5 seconds for internal BGP peers; 30 seconds for external BGP peers. Defaults seconds = 5 seconds (internal peers); seconds = 30 seconds (external peers) Command Modes ROUTER BGP Address Family (conf-router_bgp_af) Command History Version 7.8.1.0 Version 7.7.1.0 Version 7.6.1.0 Introduced support on S-Series Introduced support on C-Series Introduced IPv6 MGBP support for E-Series neighbor default-originate c et s Inject the default route to a BGP peer or neighbor. Border Gateway Protocol IPv4 (BGPv4) | 403