Dell Force10 S4820T FTOS Command Reference Guide - Page 691

Usage Information Use the count option to stop packets from flooding the user terminal when debugging is turned on. The access-group option supports only the equal to (eq) operator in TCP ACL rules. Port operators not equal to (neq), greater than (gt), less than (lt), or range are not supported in access-group option (Refer to the Example Error Messages below ). ARP packets (arp) and Ether-type (ether-type) are also not supported in access-group option. The entire rule is skipped to compose the filter. The access-group option pertains to: • IP Protocol Number 0 to 255 • Internet Control Message Protocol* icmp * but not the ICMP message type (0-255) • Any Internet Protocol ip • Transmission Control Protocol* tcp * but not on the rst, syn, or urg bit • User Datagram Protocol udp In the case of ambiguous access control list rules, the debug ip packet access-control command will be disabled. A message appears identifying the error as shown below. Example (Error Messages) FTOS#debug ip packet access-group test %Error: port operator GT not supported in access-list debug %Error: port operator LT not supported in access-list debug %Error: port operator RANGE not supported in access-list debug %Error: port operator NEQ not supported in access-list debug FTOS#00:10:45: %RPM0-P:CP %IPMGR-3-DEBUG_IP_PACKET_ACL_AMBIGUOUS_EXP: Ambiguous rules not supported in access-list debug, access-list debugging is turned off FTOS# ip address c e s Assign a primary and secondary IP address to the interface. Syntax Parameters Defaults ip address ip-address mask [secondary] To delete an IP address from an interface, use the no ip address [ip-address] command. ip-address mask secondary Enter an IP address in dotted decimal format. Enter the mask of the IP address in slash prefix format (for example, /24). (OPTIONAL) Enter the keyword secondary to designate the IP address as the secondary address. Not configured. IPv4 Routing | 691