Dell Force10 S4820T FTOS Command Reference Guide - Page 85

Usage Information Related Commands Version 7.5.1.0 Introduced on C-Series E-Series original Command The password is listed in the configuration file; you can view the password by entering the show running-config ftp command. The password configured by the ip ftp password command is used when you use the ftp: parameter in the copy command. copy ip ftp username Copy files. Set the user name for FTP sessions. ip ftp source-interface c e s Specify an interface's IP address as the source IP address for FTP connections. Syntax ip ftp source-interface interface Parameters interface Enter the following keywords and slot/port or number information: • For an 100/1000 Ethernet interface, enter the keyword GigabitEthernet followed by the slot/port information. • For a 1-Gigabit Ethernet interface, enter the keyword GigabitEthernet followed by the slot/port information. • For Loopback interfaces, enter the keyword loopback followed by a number from zero (0) to 16383. • For a Port Channel interface, enter the keyword port-channel followed by a number: C-Series and S-Series: 1-128 E-Series: 1 to 32 for EtherScale, 1 to 255 for TeraScale and 1 to 512 for ExaScale • For SONET interface types, enter the keyword sonet followed by the slot/ port information. • For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet followed by the slot/port information. • For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE followed by the slot/port information. • For a VLAN interface, enter the keyword vlan followed by a number from 1 to 4094. Defaults The IP address on the system that is closest to the Telnet address is used in the outgoing packets. Command Modes CONFIGURATION Command History Version 8.5.1.0 Version 8.2.1.0 Version 8.1.1.0 Version 7.6.1.0 Added support for 4-port 40G line cards on ExaScale. Increased number of VLANs on ExaScale to 4094 (was 2094) Introduced on E-Series ExaScale Support added for S-Series Control and Monitoring | 85