Dell Force10 S4820T FTOS Command Reference Guide - Page 1478

www.dell.com | support.dell.com Defaults Command Modes Command History Example Usage Information Related Commands day Enter the number of the day. Range: 1 to 31. You can enter the name of a month to change the order of the display to time month day year. year Enter a four-digit number as the year. Range: 1993 to 2035. Not configured EXEC Privilege Version 7.6.1.0 Version 7.5.1.0 pre-Version 6.1.1.0 Support added for S-Series Support added for C-Series Introduced for E-Series FTOS#clock set 16:20:00 19 may 2001 FTOS# You can change the order of the month and day parameters to enter the time and date as time day month year. You cannot delete the software clock. The software clock runs only when the software is up. The clock restarts, based on the hardware clock, when the switch reboots. Dell Force10 recommends that you use an outside time source, such as NTP, to ensure accurate time on the switch. ntp update-calendar Set the switch using the NTP settings. clock summer-time date c e s Set a date (and time zone) on which to convert the switch to daylight saving time on a one-time basis. Syntax Parameters clock summer-time time-zone date start-month start-day start-year start-time end-month end-day end-year end-time [offset] To delete a daylight saving time zone configuration, enter no clock summer-time. time-zone start-month Enter the three-letter name for the time zone. This name is displayed in the show clock output. Enter the name of one of the 12 months in English. You can enter the name of a day to change the order of the display to time day month year. 1478 | System Time and Date