Dell Force10 S4820T FTOS Command Reference Guide - Page 27
SPANNING TREE Mode, Per-VLAN SPANNING TREE Plus Mode, Spanning Tree Protocol STP
View all Dell Force10 S4820T manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 27 highlights
1. Verify that you are logged in to the CONFIGURATION mode. 2. Use the ip redirect-list command. You must include a name for the Redirect-list.The prompt changes to include (conf-redirect-list). You can return to the CONFIGURATION mode by entering the exit command. SPANNING TREE Mode Use the STP mode to enable and configure the Spanning Tree protocol, as described in Chapter 52, Spanning Tree Protocol (STP). To enter STP mode: 1. Verify that you are logged into the CONFIGURATION mode. 2. Enter the protocol spanning-tree stp-id command. You can return to the CONFIGURATION mode by entering the exit command. Per-VLAN SPANNING TREE Plus Mode Use PVST+ mode to enable and configure the Per-VLAN Spanning Tree (PVST+) protocol, as described in Chapter 41, Per-VLAN Spanning Tree Plus (PVST+). Note: The protocol is PVST+, but the plus sign is dropped at the CLI prompt To enter PVST+ mode: 1. Verify that you are logged into the CONFIGURATION mode. 2. Enter the protocol spanning-tree pvst command. You can return to the CONFIGURATION mode by entering the exit command. RAPID SPANNING TREE Mode Use PVST+ mode to enable and configure the RSTP protocol, as described in Chapter 45, Rapid Spanning Tree Protocol (RSTP). To enter RSTP mode: 1. Verify that you are logged into the CONFIGURATION mode. 2. Enter the protocol spanning-tree rstp command. You can return to the CONFIGURATION mode by entering the exit command. CLI Basics | 27