Dell Force10 S4820T FTOS Command Reference Guide - Page 91

Defaults Command Modes Command History Usage Information port-set0 port-number [port-number] port-set1 port-number [port-number] Enter the port number(s) used to specify the active ports on port pipe 0. Port-number range: 0 - 2. On port pipe 0, 0 - 2 corresponds to ports 0, 1, and 2 on the line card. If you configure linerate mode, enter one port number for port pipe 0. If you configure oversubscribed mode, enter two port numbers (separated by a space). Enter the port number(s) used to specify the active ports on port pipe 1. Port-number range: 0 - 2. On port pipe 1, 0 - 2 corresponds to ports 3, 4, and 5 on the line card. If you configure linerate mode, enter one port number for port pipe 1. If you configure oversubscribed mode, enter two port numbers (separated by a space). When you insert a 4-port 40Gline card in an ExaScale slot, the line card is set to operate in oversubscribed mode with active ports 1 and 2 on port pipe 0 (portset0 1 2) and active ports 0 and 1 on port pipe 1 (portset1 0 1). CONFIGURATION Version 8.5.1.0 Introduced on E-Series ExaScale E600i and E1200i. Use this command only to configure an empty slot or a slot in which you have hot-swapped a 4-port 40G line card. Before you insert a different line-card type into a slot pre-configured for a 4-port 40G line card, be sure to enter the no linecard number command. Warning: After you enter the linecard command to reconfigure a 4-port 40G line card installed in an ExaScale switch, you are prompted to reboot the line card to activate the settings. Traffic on the line card is interrupted when you reset the card. Example Related Commands On a 4-port 40G line card, there are six ports and two port pipes: 0 and 1. Each port pipe consists of three ports, one CFP port and two QSFP ports: • Ports 0, 1, and 2 use pipe 0. • Ports 3, 4, and 5 use pipe 1. To configure linerate mode, you specify one port on each pipe. To configure oversubscribed mode, you specify two ports on each pipe. FTOS(conf)# linecard 5 EX04PJ oversubscribed active-ports port-set0 1 2 port-set1 0 1 FTOS(conf)# linecard 13 EX04PH linerate active-ports port-set0 2 port-set1 0 FTOS(conf)# linecard 5 EX04PJ linerate active-ports port-set0 1 port-set1 1 Updating the linecard mode or active-ports will require a linecard reboot. Proceed with reset of linecard? [confirm yes/no]: show linecard Display the line card(s) status. Control and Monitoring | 91