Dell Force10 S4820T FTOS Command Reference Guide - Page 931

Parameters number Set the maximum number of manual area addresses. Range: 3 to 6. Default: 3 Defaults 3 addresses Command Modes ROUTER ISIS Command History Version 8.3.19.0 Version 8.3.12.0 Version 7.5.1.0 Introduced on S4820T Introduced on S4810 Expanded to support LSP Throttling Enhancement Usage Information Use this command to configure the number of area addresses on router. This value should be consistent with routers in the same area, or else, the router will form only Level 2 adjacencies. The value should be same among all the routers to form Level 1 adjacencies. max-lsp-lifetime e Set the maximum time that link-state packets (LSPs) exist without being refreshed. Syntax max-lsp-lifetime seconds To restore the default time, enter no max-lsp-lifetime. Parameters seconds The maximum lifetime of LSP in seconds. This value must be greater than the lsp-refresh-interval. The higher the value the longer the LSPs are kept. Range: 1 to 65535 Default: 1200 Defaults 1200 seconds Command Modes ROUTER ISIS Command History Version 8.3.19.0 Version 8.3.12.0 Introduced on S4820T Introduced on S4810 Usage Change the maximum LSP lifetime with this command. The maximum LSP lifetime must always be Information greater than the LSP refresh interval. The seconds parameter enables the router to keep LSPs for the specified length of time. If the value is higher, the overhead is reduced on slower-speed links. Related Commands lsp-refresh-interval Use this command to set the link-state packet (LSP) refresh interval. Intermediate System to Intermediate System (IS-IS) | 931