Dell Force10 S4820T FTOS Command Reference Guide - Page 1522

www.dell.com | support.dell.com • if the Peer VLT device was up at the time the VLTi link failed to the time when it was restored. lacp ungroup member-independent Enable BMP boot for the device connected to the LACP LAG or by a VLT peer device. Syntax Defaults Command Modes Usage Information Command History lacp ungroup member-independent {vlt | port-channel port-channel-id} Not configured. CONFIGURATION LACP on VLT ports (on a VLT switch or access device), which are members of the virtual link trunk, is not brought up until the VLT domain is recognized on the access device. During boot-up in a stacking configuration, the system must be able to reach the DHCP server with the image and configuration image. During bootup, only untagged DHCP requests are sent to the DHCP server to receive an offer on static LAGs between switches. The DHCP server must be configured to start in jumpstart mode. If switches are connected using LACP port-channel like the VLT peer and ToR, use the port-channel parameter on the TOR side of the configuration to allow member ports of a completely un-grouped lacp port-channel to inherit vlan membership of that port channel to ensure untagged packets sent by a VLT peer device reach the DHCP server located on the TOR. To ungroup the vlt and port-channel configurations, use the no lacp ungroup member-independent vlt command on a VLT port channel, depending on whether the port channel is VLT or non-VLT.. Version 8.3.19.0 Version 8.3.12.0 Version 8.3.8.0 Introduced on S4820T Added port-channel parameter. Introduced on S4810 peer-link Configure the peer-link for VLT Syntax Defaults Command Modes peer-link Not configured. VLT DOMAIN 1522 | Virtual Link Trunking (VLT)