Dell Force10 S4820T FTOS Command Reference Guide - Page 669
for routed packets use the, display flows for switched Layer 2 packets
View all Dell Force10 S4820T manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 669 highlights
Parameters outgoing-port-channel number incoming-interface interface source-ip address destination-ip address protocol number | icmp | tcp | udp source-port number destination-port number source-mac address destination-mac address Enter the keyword outgoing-port-channel followed by the number of the port channel to display flow information. • For a Port Channel interface, enter the keyword port-channel followed by a number: C-Series and S-Series Range: 1 to 128 E-Series Range: 1 to 32 for EtherScale, 1 to 255 for TeraScale and 1 to 512 for ExaScale. Enter the keyword incoming-interface followed by the interface type and slot/port or number information: • For a Fast Ethernet interface, enter the keyword FastEthernet followed by the slot/port information. • For a 1-Gigabit Ethernet interface, enter the keyword GigabitEthernet followed by the slot/port information. • For a SONET interface, enter the keyword sonet followed by the slot/port information. • For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet followed by the slot/port information. • For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE followed by the slot/port information. Enter the keyword source-ip followed by the IP source address in IP address format. Enter the keyword destination-ip followed by the IP destination address in IP address format. On the E-Series only, enter the keyword protocol followed by one of the protocol type keywords: tcp, udp, icmp or protocol number Note: The protocol number keyword applies to E-Series only. Enter the keyword source-port followed by the source port number. Range: 1 to 65536 Default: None Enter the keyword destination-port followed by the destination port number. Range: 1 to 65536 Default: None Enter the keyword source-mac followed by the MAC source address in the nn:nn:nn:nn:nn:nn format. Enter the keyword destination-mac followed by the MAC destination address in the nn:nn:nn:nn:nn:nn format. Command Modes EXEC Command History Version 8.3.19.0 Introduced on S4820T Version 8.3.10.0 Introduced on S4810 Usage Information Since this command calculates based on a Layer 2 hash algorithm, use this command to display flows for switched Layer 2 packets, not for routed packets (use the show ip flow command to display routed packets). Interfaces | 669