Dell Force10 S4820T FTOS Command Reference Guide - Page 338

www.dell.com | support.dell.com Parameters Defaults Command Modes Usage Information Command History ip-address peer-group-name activate (OPTIONAL) Enter the IP address of the neighbor in dotted decimal format. (OPTIONAL) Enter the name of the peer group Enter the keyword activate to enable the neighbor/peer group in the new AFI/SAFI. Disabled CONFIGURATION-ROUTER-BGP-ADDRESS FAMILY By default, when a neighbor/peer group configuration is created in the Router BGP context, it is enabled for the IPv4/Unicast AFI/SAFI. By using activate in the new context, the neighbor/peer group is enabled for AFI/SAFI. Version 8.3.19.0 Version 8.3.7.0 Version 7.8.1.0 Version 7.7.1.0 Introduced on the S4820T. Introduced on the S4810. Introduced support on S-Series Introduced support on C-Series neighbor add-path This command allows the specified neighbor/peer group to send/receive multiple path advertisements. Syntax Parameters Defaults Command Modes Related Commands neighbor [ip-address | peer-group-name] add-path [send | receive | both] count ip-address peer-group-name send receive both count (OPTIONAL) Enter the IP address of the neighbor in dotted decimal format. (OPTIONAL) Enter the name of the peer group. Enter this keyword to indicate that the system will send multiple paths to peers. Enter this keyword to indicate that the system will accept multiple paths from peers. Enter this keyword to indicate that the system will send and accept multiple paths from peers. Enter the number paths supported. Range: 2 to 64 none CONFIGURATION-ROUTER-BGP-ADDRESS FAMILY bgp add-path Allow the advertisement of multiple paths for the same address prefix without the new paths implicitly replacing any previous ones. 338 | Border Gateway Protocol IPv4 (BGPv4)