Dell Force10 S4820T FTOS Command Reference Guide - Page 974

www.dell.com | support.dell.com Parameters Command Modes Command History stack-unit unit_number port-set port-pipe address mac-addr dynamic static interface interface vlan vlan-id EXEC EXEC Privilege (REQUIRED) Enter the keyword linecard followed by a stack member number to select the linecard for which to gather information. S-Series Range: 0 to 1 (REQUIRED) Enter the keyword port-set followed by a Port-Pipe number to select the Port-Pipe for which to gather information. S-Series Range: 0 or 1 (OPTIONAL) Enter the keyword address followed by a MAC address in the nn:nn:nn:nn:nn:nn format to display information on that MAC address. (OPTIONAL) Enter the keyword dynamic to display only those MAC addresses learned dynamically by the switch. (OPTIONAL) Enter the keyword static to display only those MAC address specifically configured on the switch. (OPTIONAL) Enter the keyword interface followed by the interface type, slot and port information: • For a 1-Gigabit Ethernet interface, enter the keyword GigabitEthernet followed by the slot/port information. • For a Port Channel interface, enter the keyword port-channel followed by a number: S-Series Range: 1 to 128 • For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet followed by the slot/port information. • For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE followed by the slot/port information. (OPTIONAL) Enter the keyword vlan followed by the VLAN ID to display the MAC address assigned to the VLAN. Range: 1 to 4094. Version 8.5.1.0 Version 7.6.1.0 Added support for 4-port 40G line cards on ExaScale. This version of the command introduced for S-Series show mac-address-table c e s Display the MAC address table. Syntax show mac-address-table [dynamic | static] [address mac-address | interface interface | vlan vlan-id] [count [vlan vlan-id] [interface interface-type [slot [/port]]]] 974 | Layer 2