Dell Force10 S4820T FTOS Command Reference Guide - Page 894

www.dell.com | support.dell.com Usage You can configure iSCSI TLVs to be sent either globally or on a specified interface. The interface Information configuration takes priority over global configuration. iscsi aging time Set the aging time for iSCSI sessions. Syntax iscsi aging time time To remove the iSCSI session aging time, use the no iscsi aging time command. Parameters time Enter the aging time for the iSCSI session. Range: 5 to 43,200 minutes. Defaults 10 minutes. Command Mode CONFIGURATION Command History Version 8.3.19.0 Version 8.3.12.0 Version 8.3.16.0 Introduced on the S4820T. Introduced on the S4810. Introduced on MXL 10/40GbE Switch IO Module iscsi cos Set the QoS policy that will be applied to the iSCSI flows. Syntax Parameters iscsi cos {enable | disable | dot1p vlan-priority-value [remark] | dscp dscp-value [remark]} To disable the QoS policy, use the no iscsi cos dscp command. enable disable dot1p vlan-priority-value Enter the keyword enable to allow the application of preferential QoS treatment to iSCSI traffic so that the iSCSI packets are scheduled in the switch with a dot1p priority 4 regardless of the VLAN priority tag in the packet. Default: iSCSI packets are handled with dotp1 priority 4 without remark. Enter the keyword disable to disable the application of preferential QoS treatment to iSCSI frames. Enter the dot1p value of the VLAN priority tag assigned to the incoming packets in an iSCSI session. Range: 0 to 7. Default: The dot1p value in ingress iSCSI frames is not changed and is used in iSCSI TLV advertisements if you did not enter the iscsi priority-bits command. 894 | iSCSI Optimization