Dell Force10 S4820T FTOS Command Reference Guide - Page 1237

rate-shape c e s Shape traffic output as part of the designated policy. Syntax rate-shape [kbps] rate [burst-KB] Parameters kbps rate burst-KB Enter this keyword to specify the rate limit in Kilobits per second (Kbps). On C-Series and S-Series make the following value a multiple of 64. The default granularity is Megabits per second (Mbps). Range: 0-10000000 Enter the outgoing rate in multiples of 10 Mbps. Range: 10 to 10000 (OPTIONAL) Enter a number as the burst size in KB. Range: 0 to 10000 Default: 10 Defaults Burst size is 10 KB. Granularity for rate is Mbps unless the kbps option is used. Command Modes QOS-POLICY-OUT Command History Usage Information Version 8.3.19.0 Introduced on S4820T Version 8.3.7.0 Introduced on S4810 Version 8.2.1.0 Added kbps option on C-Series, E-Series, and Series. Version 7.6.1.0 Introduced on S-Series Version 7.5.1.0 Introduced on C-Series pre-Version 6.1.1.1 Introduced on E-Series rate-shape can be applied only as an aggregate policy. If it is applied as a class-based policy, then rate-shape will not take effect. On 40-port 10G linecards, if the traffic is shaped between 64 and 1000kbs, for some values the shaped rate is much less than the value configured. Do not use values in this range for 10G interfaces. Related Commands rate shape Shape the traffic output of the selected interface. qos-policy-output Create a QoS output policy. service-class dot1p-mapping Configure a service-class criterion, based on a dot1p value. Quality of Service (QoS) | 1237