Dell Force10 S4820T FTOS Command Reference Guide - Page 664

www.dell.com | support.dell.com If the line card is in a Jumbo mode chassis, then the mtu and ip mtu commands can also be configured. The Link MTU and IP MTU values configured on the channel members must be greater than the Link MTU and IP MTU values configured on the Port Channel interface. Note: In a Jumbo-enabled system, all members of a Port Channel must be configured with the same link MTU values and the same IP MTU values. Related Commands channel-member interface interface loopback interface null interface vlan shutdown Add a physical interface to the LAG. Configure a physical interface. Configure a Loopback interface. Configure a null interface. Configure a VLAN. Disable/Enable the port channel. minimum-links c e s Configure the minimum number of links in a LAG (Port Channel) that must be in "oper up" status for the LAG to be also in "oper up" status. Syntax minimum-links number Parameters number Enter the number of links in a LAG that must be in "oper up" status. Range: 1 to 16 Default: 1 Defaults 1 Command Modes INTERFACE Command History Version 8.3.19.0 Version 8.3.7.0 Version 8.1.1.0 Version 7.6.1.0 Version 7.5.1.0 pre-Version 6.2.1.0 Introduced on S4820T Introduced on S4810 Introduced on E-Series ExaScale Introduced on S-Series Introduced on C-Series Introduced for E-Series Usage Information If you use this command to configure the minimum number of links in a LAG that must be in "oper up" status, then the LAG must have at least that number of "oper up" links before it can be declared as up. For example, if the required minimum is four, and only three are up, then the LAG will be considered down. 664 | Interfaces