Dell Force10 S4820T FTOS Command Reference Guide - Page 353

neighbor remove-private-as c e s Remove private AS numbers from the AS-PATH of outgoing updates. Syntax neighbor {ip-address | peer-group-name} remove-private-as To return to the default, use the no neighbor {ip-address | peer-group-name} remove-private-as command. Parameters ip-address peer-group-name Enter the IP address of the neighbor to remove the private AS numbers. Enter the name of the peer group to remove the private AS numbers Defaults Disabled (that is, private AS number are not removed). Command Modes ROUTER BGP Usage Information Applies to EBGP neighbors only. You must configure your system to accept 4-byte formats before entering a 4-byte AS Number. If the AS-PATH contains both public and private AS number or contains AS numbers of an EBGP neighbor, the private AS numbers are not removed. If a confederation contains private AS numbers in its AS-PATH, the software removes the private AS numbers only if they follow the confederation numbers in the AS path. Private AS numbers are 64512 to 65535 (2-Byte). Command History Version 8.3.19.0 Version 8.3.7.0 Version 7.8.1.0 Version 7.7.1.0 Introduced on the S4820T. Introduced on the S4810. Introduced support on S-Series Introduced support on C-Series Added 4-Byte support. neighbor route-map c e s Apply an established route map to either incoming or outbound routes of a BGP neighbor or peer group. Syntax neighbor {ip-address | peer-group-name} route-map map-name {in | out} Border Gateway Protocol IPv4 (BGPv4) | 353