Dell Force10 S4820T FTOS Command Reference Guide - Page 1280
Parameters, Defaults, Command Modes, Command, History, Usage, Information, Related, Commands, Syntax, Parameter
View all Dell Force10 S4820T manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 1280 highlights
www.dell.com | support.dell.com Parameters Defaults Command Modes Command History Usage Information Related Commands ip-address Enter the IP address, in dotted decimal format, of a router with which to exchange information. Not configured. ROUTER RIP Version 8.3.19.0 Version 8.3.7.0 Version 7.8.1.0 Version 7.6.1.0 pre-Version 6.2.1.1 Introduced on S4820T Introduced on S4810 Introduced on S-Series Introduced on C-Series Introduced on E-Series When a neighbor router is identified, unicast data exchanges occur. Multiple neighbor routers are possible. Use the passive-interface command in conjunction with the neighbor command to ensure that only specific interfaces are receiving and sending data. passive-interface Sets the interface to only listen to RIP broadcasts. network c e s Enable RIP for a specified network. Use this command to enable RIP on all networks connected to the switch. Syntax Parameter Defaults Command Modes Command History network ip-address To disable RIP for a network, use the no network ip-address command. ip-address Specify an IP network address in dotted decimal format. You cannot specify a subnet. No RIP network is configured. ROUTER RIP Version 8.3.19.0 Version 8.3.7.0 Version 7.8.1.0 Version 7.6.1.0 pre-Version 6.2.1.1 Introduced on S4820T Introduced on S4810 Introduced on S-Series Introduced on C-Series Introduced on E-Series 1280 | Routing Information Protocol (RIP)