Dell Force10 S4820T FTOS Command Reference Guide - Page 1406

www.dell.com | support.dell.com Usage Information Related Commands Sample-rate is the average number of packets skipped before the sample is taken. This command changes the global default sampling rate. You can configure an interface to use a different sampling rate than the global sampling rate. If the value entered is not a correct power of 2, the command generates an error message with the previous and next power of 2 value. Select one of these two packet numbers and re-enter the command. sflow sample-rate (Interface) Change the Interface sampling rate. sflow sample-rate (Interface) c e s Change the Interface default sampling rate. Syntax Parameters Defaults Command Modes Command History Usage Information Related Commands sflow sample-rate value To return to the default sampling rate, enter the no sflow sample-rate. value Enter the sampling rate value. Range: C-Series and S-Series: 256 to 8388608 packets E-Series TeraScale and ExaScale: 2 to 8388608 packets Enter values in powers of 2 only, for example 4096, 8192, 16384 etc. Default: 32768 packets The Global default sampling CONFIGURATION Version 8.3.19.0 Version 8.3.7.0 Version 8.2.1.0 Version 8.1.1.0 Version 7.7.1.0 Version 7.6.1.0 Version 6.2.1.1 Introduced on S4820T Introduced on S4810 Introduces on S-Series Stacking Introduced on E-Series ExaScale Introduced on S-Series Introduced on C-Series Introduced on E-Series This command changes the sampling rate for an Interface. By default, the sampling rate of an interface is set to the same value as the current global default sampling rate. If the value entered is not a correct power of 2, the command generates an error message with the previous and next power-of-2 value. Select one of these two number and re-enter the command. sflow sample-rate (Global) Change the sampling rate globally. 1406 | sFlow