Dell Force10 S4820T FTOS Command Reference Guide - Page 1293

Default Command Modes Command History falling-threshold value event-number owner string Enter the keyword falling-threshold followed by the value (32bit) the falling-threshold alarm is either triggered or reset. Then enter the event-number to trigger when the falling threshold exceeds its limit. This value is the same as the alarmFallingEventIndex or the alarmTable of the RMON MIB. If there is no corresponding falling-threshold event, the value is zero. (OPTIONAL) Enter the keyword owner followed by the owner name to specify an owner for the alarm. This is the alarmOwner object in the alarmTable of the RMON MIB. owner CONFIGURATION Version 8.3.19.0 Version 8.3.11.1 Version 8.3.7.0 Version 7.6.1.0 Version 7.5.1.0 Version 6.1.1.0 Introduced on S4820T Introduced on Z9000 Introduced on S4810 Support added for S-Series Support added for C-Series Introduced for E-Series rmon collection history c e s z Enable the RMON MIB history group of statistics collection on an interface. Syntax Parameters rmon collection history {controlEntry integer} [owner name] [buckets number] [interval seconds] To remove a specified RMON history group of statistics collection, use the no rmon collection history {controlEntry integer} command. controlEntry integer owner name Enter the keyword controlEntry to specify the RMON group of statistics using a value. Then enter an integer value from 1 to 65535 that identifies the RMON group of statistics. The integer value must be a unique index in the RMON History Table. (OPTIONAL) Enter the keyword owner followed by the owner name to record the owner of the RMON group of statistics. Remote Monitoring (RMON) | 1293