Dell Force10 S4820T FTOS Command Reference Guide - Page 632

www.dell.com | support.dell.com Parameters interface Enter one of the following keywords and slot/port or number information: • For a Fast Ethernet interface, enter the keyword FastEthernet followed by the slot/port information. • For a 1-Gigabit Ethernet interface, enter the keyword GigabitEthernet followed by the slot/port information. • For a Loopback interface, enter the keyword loopback followed by a number from 0 to 16383. • For the management interface on an RPM, enter the keyword ManagementEthernet followed by the slot/port information. The slot range is 0 to 1 and the port range is 0. • For a Null interface, enter the keywords null 0. • For a Port Channel interface, enter the keyword port-channel followed by a number: C-Series and S-Series Range: 1 to 128 E-Series Range: 1 to 32 for EtherScale, 1 to 255 for TeraScale and 1 to 512 for ExaScale. • For a SONET interface, enter the keyword sonet followed by the slot/port. • For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet followed by the slot/port information. • For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE followed by the slot/port information. • For a VLAN interface, enter the keyword vlan followed by a number from 1 to 4094. Command Modes EXEC EXEC Privilege Command History Version 8.3.19.0 Version 8.5.1.0 Version 8.3.7.0 Version 8.2.1.2 Version 8.2.1.0 Version 8.1.1.0 Version 7.8.1.0 Version 7.6.1.0 Version 7.5.1.0 Version 6.4.1.0 Version 6.3.1.0 Introduced on S4820T Added support for 4-port 40G line cards on ExaScale. Introduced on S4810 Include SFP and SFP+ optics power detail in E-Series and C-Series output. Support for 4093 VLANs on E-Series ExaScale. Prior releases supported 2094. Introduced on E-Series ExaScale Output expanded to include SFP+ media in C-Series Introduced on S-Series Introduced on C-Series Changed organization of display output Added Pluggable Media Type field in E-Series TeraScale output Usage Use this show interfaces command for details on a specific interface. Use the show interfaces Information linecard command for details on all interfaces on the designated line card. Note that, in an E-Series EtherScale chassis, the show interfaces command output does not include details about installed SFP or XFP transceivers. On the S4810, the show interface output displays incorrect rate information details over time for link monitoring when the rate-interval is configured for 5 seconds. Dell Force10 recommends using higher rate-intervals such as 15 to 299 seconds to minimize the errors 632 | Interfaces