Dell Force10 S4820T FTOS Command Reference Guide - Page 935

To end redistribution or disable any of the specified keywords, enter the no redistribute {static | connected | rip} [metric metric-value] [metric-type {external | internal}] [level-1 | level-1-2 | level-2] [route-map map-name] command. Parameters connected rip static metric metric-value metric-type {external | internal} level-1 level-1-2 level-2 route-map map-name Enter the keyword connected redistribute active routes into IS-IS. Enter the keyword rip to redistribute RIP routes into IS-IS. Enter the keyword static to redistribute user-configured routes into IS-IS. (OPTIONAL) Assign a value to the redistributed route. Range: 0 to 16777215 Default: 0. You should use a value that is consistent with the destination protocol. (OPTIONAL) The external link type associated with the default route advertised into a routing domain. You must specify one of the following: • external • internal (OPTIONAL) Routes are independently redistributed into IS-IS as Level 1 routes. (OPTIONAL) Routes are independently redistributed into IS-IS as Level-1-2 routes. (OPTIONAL) Routes are independently redistributed into IS-IS as Level 2 routes. This is the default. (OPTIONAL) If the route-map argument is not entered, all routes are redistributed. If a map-name value is not specified, then no routers are imported. Defaults metric metric-value = 0; metric-type= internal; level-2 Command Modes ROUTER ISIS (for IPv4) CONFIGURATION-ROUTER-ISIS-ADDRESS-FAMILY-IPV6 (for IPv6) Command History Version 8.3.19.0 Version 8.3.12.0 Version 7.5.1.0 Version 6.3.1.0 Introduced on S4820T Introduced on S4810 Introduced IPv6 ISIS support Introduced Usage Information To redistribute a default route (0.0.0.0/0), configure the default-information originate command. Changing or disabling a keyword in this command will not affect the state of the other command keywords. When an LSP with an internal metric is received, the FTOS considers the route cost taking into consideration the advertised cost to reach the destination. Redistributed routing information is filtered with the distribute-list out command to ensure that the routes are properly are passed to the receiving routing protocol. Intermediate System to Intermediate System (IS-IS) | 935