Dell Force10 S4820T FTOS Command Reference Guide - Page 990

www.dell.com | support.dell.com track ip c e s Track the Layer 3 operational state of a Layer 3 VLAN, using a subset of the VLAN member interfaces. Syntax Parameters Defaults Command Modes Command History Usage Information Related Commands track ip interface To remove the tracking feature from the VLAN, use the no track ip interface command. interface Enter the following keywords and slot/port or number information: • For a 1-Gigabit Ethernet interface, enter the keyword GigabitEthernet followed by the slot/port information. • For a Port Channel interface, enter the keyword port-channel followed by a number: C-Series and S-Series Range: 1 to 128 E-Series Range: 1 to 255 for TeraScale and 1 to 512 for ExaScale. • For a SONET interface, enter the keyword sonet followed by the slot/port information. • For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet followed by the slot/port information. • For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE followed by the slot/port information. Not configured INTERFACE VLAN Version 8.3.19.0 Version 8.5.1.0 Version 8.3.7.0 Version 7.6.1.0 Version 7.5.1.0 pre-Version 6.2.1.1 Introduced on S4820T. Added support for 4-port 40G line cards on ExaScale. Introduced on S4810 Introduced on S-Series Introduced on C-Series Introduced on E-Series When this command is configured, the VLAN is operationally UP if any of the interfaces specified in the track ip command are operationally UP, and the VLAN is operationally DOWN if none of the tracking interfaces are operationally UP. If the track ip command is not configured, the VLAN's Layer 3 operational state depends on all the members of the VLAN. The Layer 2 state of the VLAN, and hence the Layer 2 traffic is not affected by the track ip command configuration. interface vlan tagged Configure a VLAN. Specify which interfaces in a VLAN are tagged. 990 | Layer 2