Dell Force10 S4820T FTOS Command Reference Guide - Page 984

www.dell.com | support.dell.com Command History Example Version 8.1.1.2 Version 8.1.1.0 Introduced on E-Series ExaScale E600i Introduced on E-Series ExaScale E1200i FTOS(conf)#enable vlan-output-counters FTOS(conf)#exit FTOS#show interface vlan 101 Vlan 101 is down, line protocol is down Address is 00:01:e8:26:e0:5b, Current address is 00:01:e8:26:e0:5b Interface index is 1107787877 Internet address is not set MTU 1554 bytes, IP MTU 1500 bytes LineSpeed 1000 Mbit ARP type: ARPA, ARP Timeout 04:00:00 Last clearing of "show interface" counters 01:12:44 Queueing strategy: fifo Input Statistics: 0 packets, 0 bytes Output Statistics: 0 packets, 0 bytes Time since last interface status change: 01:12:44 FTOS# Usage Information FTOS#show interfaces vlan 1 Vlan 1 is down, line protocol is down Address is 00:01:e8:13:a5:aa, Current address is 00:01:e8:13:a5:aa Interface index is 1107787777 Internet address is not set MTU 1554 bytes, IP MTU 1500 bytes LineSpeed 1000 Mbit ARP type: ARPA, ARP Timeout 04:00:00 Last clearing of "show interface" counters 01:36:01 Queueing strategy: fifo Input Statistics: 100000 packets, 10000000 bytes Output Statistics: 200000 packets, 20800000 bytes Time since last interface status change: 01:36:01 FTOS# FTOS supports a command to enable viewing of the VLAN input/output counters. This command also applies to SNMP requests. If the command is not enabled, IFM returns zero values for VLAN output counters. SNMP counters differ from show interface counters as SNMP counters must maintain history. At any point, the value of SNMP counters reflect the amount of traffic being carried on the VLAN. VLAN output counters may show higher than expected values because source-suppression drops are counted. 984 | Layer 2